10-13-2009, 07:27 PM
How were this little four sided suspensions produced ?
Are they stamped with a machine out of a sheet of silver and than the lower hole for the mounting ring was drilled in with a electric drill. And finally the edges and border of the suspension were polished / deburring with a kind of rasp?
best regards and thanks
Andreas
Are they stamped with a machine out of a sheet of silver and than the lower hole for the mounting ring was drilled in with a electric drill. And finally the edges and border of the suspension were polished / deburring with a kind of rasp?
best regards and thanks
Andreas












